Slide Milling for Slim Line or Single Stack Pistols

Milling for the Holosun K footprint optics (407K/507K/EPS/EPS Carry) is not available for S&W M&P Shield slides at this time.

Glock 42 slides can be milled for Holosun 407K/507K/EPS/EPS Carry ONLY.

The existing pocket is modified for Glock 43X MOS, Glock 48 MOS or Sig P365 Optics Ready slides.

Half Top Front Slide Serrations are NOT available for Glock 42 or Sig p365 Slides.

Top Porting is NOT available for Glock 42, S&W M&P Shield or Sig P365 Slides.

Enhanced Serration Glock Sides Front & Rear with Porting Within Front Side Serrations is not available for Glock slides such as the 43, 43X and 48.

There is a Glock logo on the rear right side of the slide after the ejection port that is cut through, even when this option is selected. If you would like that logo left behind, that is a modification of the program and there is an additional cost. For this option, you would choose ENHANCED SERRATION GLOCK SIDES FRONT & REAR, LEAVE ROLLMARKS BOTH SIDES $160.

All slides listed would either need to use the ATEi Shimsight or have a new dovetail milled in front of the optic or in some cases behind the optic.

Only the Sig P365 can use the factory dovetail with RMRcc or Holosun optics.

S&W M&P Shield will need a new rear dovetail milled Behind, IN FRONT or use the ATEi ShimSight.